台达b2伺服驱动器电机正反转设置
作者：刚仲夜 | 发布日期：2024-09-23 08:08:32
⑴Delta ADSA-B2 series servo motor has pulse input but the motor does not rotate. How to set the parameters? Thanks!
The most basic steps of servo setup.
1. Electronic gear ratio;
2. Control mode (position, speed and torque);
3. Pulse control mode (generally there are three types, positive and negative of AB phase pulse cw/ccw Direction pulse and pulse + direction control)
4. Position gain, system gain, etc., if there are no special requirements, just set it to automatic setting
Finally, set the servo SERVOON at startup. Then, pulse.
1. Electronic gear ratio;
2. Control mode (position, speed and torque);
3. Pulse control mode (generally there are three types, positive and negative of AB phase pulse cw/ccw Direction pulse and pulse + direction control)
4. Position gain, system gain, etc., if there are no special requirements, just set it to automatic setting
Finally, set the servo SERVOON at startup. Then, pulse.
1. First, loosen the maintenance of Delta b2 servo driver.
2. Secondly, determine the position of the locking proximity switch.
3. Finally, perform loosening, locking switching and other faults in manual mode.
2. Secondly, determine the position of the locking proximity switch.
3. Finally, perform loosening, locking switching and other faults in manual mode.